Start a training and set the lineup

Home has Start training when the kennel has dogs. The training gets the current time as its start and opens on the lineup. Planning one for later is done under Trainings with Plan.

Building the lineup

1. Tap a dog, then the slot where it runs. Or tap an empty slot first and then the dog for that row.
2. Tap a placed dog and then another slot to move it, or another dog to swap them.
3. New row adds a row at the back. Rows go from the lead row to the wheel row, with the names set under Settings, Kennel.

Every tap is saved as it happens, and the bar at the bottom says Saved, Saving or Not saved. Two handlers can work on the same lineup; nobody overwrites anybody, and if someone else changed it meanwhile, the message says so with Undo.

Warnings and remarks

Placing a male next to a female in heat asks first. Each dog can get a remark for this training from its slot.

Without connection the taps are kept and sent once there is signal. Leaving to another training first saves what was not saved yet.